Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 863)

Allen-Bradley 7300 Series CNC
Tape Compatibility
Appendix D
D-13
Table D.C (continued)
9/Series Lathe G-codes Available in 7300 Mode
G-code: Description:
G55 Preset work coordinate system 2
G56 Preset work coordinate system 3
G57 Preset work coordinate system 4
G58 Preset work coordinate system 5
G59 Preset work coordinate system 6
G61 Exact stop mode
G62 Automatic corner override
G63 Tapping mode
G64 Cutting mode
G65 Paramacro call
G66 Paramacro modal call
G67 Paramacro modal cancel
The control does not support these 7300 Series CNC features:
any of the lathe canned cycles (G80 to G83)
7300 Scaling using “SCF” with G-codes (9/Series available)
7300 Part Rotation
additional plane selection (beyond G17, G18 and G19)
7300 Tool Axis Switching
7300 Tool Tip Radius Compensation (TTRC) entry and exit motion
All TTRC moves, except for the entry and exit moves, use the same
paths for 7300 and 9/Series. However, the entry and exit moves of
cutter compensation use the 9/Series control’s tool paths. Refer to
chapter 21 for details.
END OF APPENDIX
7300 Series Features Not
Supported