Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 138)

Editing Programs On Line
Chapter 5
5-32
STORE
END PT
EDIT &
STORE
E-STOP
DIGITIZE:
TARGET[ MM ]
Z 0.000
R
X 0.000
C 359.99
F 0.000 MMPM S 00
2. Reposition the tool at the desired end-point of the linear move using
any of these methods:
Jog the Axes in manual mode.
Automatically move the axes by executing a part program or MDI
program.
Manually move the axes using any means as long as the encoder is
still actively recording the tool position (see documentation
prepared by the system installer).
3. After you position the axes at the end-point of the linear move, press
either the
{STORE END PT}
or the
{EDIT & STORE}
softkeys. This
records the current tool location as the final position for this digitize
operation.
Digitize screens cannot be displayed as split screens.