Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 305)

Introduction to Programming
Chapter 10
10-37
Table 10.G
T-word Formats
Format Type Wear Offset # Geometry Offset #
(1) 1 DGT GEOM + WEAR last digit same as wear
(2) 2 DGT GEOM + WEAR last two digits same as wear #
(3) 3 DGT GEOM + WEAR last three digits same as wear #
(4) 1 DGT WEAR last digit same as tool #
(5) 2 DGT WEAR last two digits same as tool #
(6) 3 DGT WEAR last three digits same as tool #
For details on programming a T-word discussing tool length offsets, see
chapter 20.
END OF CHAPTER