Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 200)

Running a Program
Chapter 7
7-24
Command: Process:
CYCLE START begins part program execution
CYCLE STOP
stops part program execution
WARNING: Always test a program prior to automatic
operation. Always verify that the workspace is clear and all
safety features are intact before pressing
<CYCLE START>
.
Figure 7.4
Automatic Mode
S_____ M _____
G92 X ____ Z ____
D _________
G00_________
G01 F_______
CUTTING TOOL
CYCLE
START
WORK PIECE
12345 0
Execution of a part program continues until the control encounters an M02
or M30. If the control does not encounter an M02 or M30 at the end of a
program, the error message “MISSING M02/M30” appears.
You can stop execution at any time by using any of the methods described
on page 7-6 or by pressing the
<EMERGENCY STOP>
button.