Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 172)

Editing Part Programs Off Line
Chapter 6
6-16
8. Use the arrow keys to highlight the name of the part program to be
uploaded to the workstation or type in the part program name, then
press
[ENTER]
.
When you upload a program from the control, the control does not display
a message to indicate that an upload is taking place. If you upload a large
program it may take several minutes for the upload to complete. If you try
to edit the program while it is uploading you see an error message that says
the program is already open. You have to wait until the upload is complete
to edit the program.
Important: You can upload more than one part program by using
wildcards (“*” or “?”) in place of all or part of a file name. Refer to the
workstation’s DOS manual for additional information about using
wildcards.
If the selected part program already exists on the workstation, the
workstation displays this screen:
F1 - File F2 - Project F3 - Application F4 - Utility F5 - Configuration
Proj: Demo Appl: Upload Util: Get Part Program
File Already Exits
Enter Option
Rename existing file
Overwrite existing file
Abort current file
(R)
(O)
(A)