Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 867)

9/Series PAL Reference Manual
Index (General)
9/Series Lathe
Index
Operation and Programming Manual
iii
Displaying Position
ABS, 8-6
ABS (Large Display), 8-7
absolute (Small Display), 8-7
ALL, 8-19
distance to go (Small Display), 8-13
DTG, 8-12
DTG (Large Display), 8-13
G Code Status, 8-20
M Code Status, 8-16
PRGRAM, 8-3
PRGRAM (Large Display), 8-4
PRGRAM (Small Display), 8-5
PRGRAM DTG, 8-17
program/DTG (Small Display), 8-18
Target, 8-9
Target (Large Display), 8-10
target (Small Display), 8-10
Distance to Go Position Display, 8-12
Downloading Part Programs from ODS, 6-6
Drilling Axis, on dual axis, 30-41
Drilling Cycle, Prompting Format, 5-25
Drilling Cycle Operations, 26-8
Drilling Cycle Parameter, Altering, 26-38
Drilling Cycle, Cancel, 26-8
Drilling Cycle, Dwell/Rapid Out (G82), 26-10
Drilling Fixed Cycle
Drilling Cycle Operations, 26-8
Drilling Cycle, No Dwell/Rapid Out (G81), 26-9
Drilling Cycles, 26-1
Dry Run, 7-21
Dual Axis
Configuration, 19-1
Homing, 19-4
Invalid Operations, 19-6
Offsets for, 19-7
on Dual Processing, 30-37
Parking, 19-3
Programming, 19-5
programming de-coupled axis on dual processing,
30-40
shared drilling axis, 30-41
Terms, 19-2
Dual-Processing, 30-1
Active Process, 30-2
Cycle Start, 30-2
Cycle Stop, 30-11
De-coupling duals, 30-38
Definition, 30-1
dual axes on, 30-37
Dual-Turret Lathe, 30-1
Editing a Part Program, 30-4
Error Messages, 30-5
Graphics, 30-4
Interference Boundaries, 30-22
Interference Checking, 30-19
Interference Values, 30-25, 30-27
MDI Mode, 30-11, 30-14
Operating a Shared Axis, 30-32
Operation, 30-2
Part Program Directory, 30-3
Preventing Collisions, 30-21
QuickView, 30-4
Reset Operations, 30-6
Separate Spindle Configuration, 30-18
Shared Axes, 30-32
Shared Parameters, 30-6
Shared Spindle Configuration, 30-12
Single-Digit Feedrates, 30-5
Spindle Control, 30-12
Split Screen Display, 30-3
Switching a Shared Axis, 30-34
Synchronizing Part Programs, 30-7
Dual-Turret Lathe, 30-1
Dwell, 14-18
Seconds, 14-18
Spindle Revolutions, 14-19
E
Editing a Part Program for Dual-Processing, 30-4
Editing a Program
Protectable Program Directory, 5-42
Selecting, 5-2
Editing Part Programs Offline, 6-3
Editing Programs, 5-4