Rockwell Automation 8520 9/Series CNC Lathe User Manual
Page 600
Advertising
Compounding Turning Routines
Chapter 24
24-36
In Example 24.9, the workpiece contour blocks are blocks N11 - N14.
Example 24.9
Typical G72 Block Followed by Blocks Defining Final Contour
N005 G72P11Q14;
.
.
.
N010 M30.;
N011 X24.;
N012 X55.Z40.;
N013 X65.Z35.;
N014 X70.Z5.;
The G72 routine can be programmed while the tool tip radius
compensation mode (G41 or G42) is active. If tool tip radius
compensation is active prior to the G72 block, it remains active
throughout the execution of this routine.
END OF CHAPTER
Advertising