Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 141)

Editing Programs On Line
Chapter 5
5-35
Figure 5.6
CIRCLE TANGNT Digitize Screen
STORE
END PT
EDIT &
STORE
E-STOP
DIGITIZE:
TARGET[ MM
Z - 0.000
R
X - 0.000
C -359.99
F 0.000 MMPM S 00
2. Reposition the tool at the end point of the arc using any of these
methods:
Jog the Axes in manual mode.
Automatically move the axes by executing a part program or MDI
program.
Manually move the axes using any means as long as the encoder is
still actively recording the tool position (see documentation
prepared by the system installer).
3. After the axes have been positioned at the end point of the arc, press
either the
{STORE END PT}
or the
{EDIT & STORE}
softkeys. The
control stores the current tool position as the end point of the arc.