Rockwell Automation Liqui-Flo V2.0 AC Drive User Manual
Page 123
Rockwell Automation Publication D2-3518-3 - May 2013
123
Chapter 9
Displays the source that initiated the most recent stop sequence. It is cleared (set
to 0) during the next start sequence.
For Frame 3 drives, this parameter provides the state of the user-configurable
Digital Inputs on the optional A22 Standard I/O board.
For Frame 4 drives, this parameter provides the state of the user-configurable
Digital Inputs on the A12 Combined I/O board.
AC Line I/O Board Description (Frame 3 Only) on page 25
through
Combined I/O Board Description (Frame 4 Only) on page 29
for a description
of I/O hardware that is present on this drive and is controlled by the inverter.
Figure 50 - Dig In Status (216)
For Frame 3 drives (firmware version 1.x), this parameter is only usable if an
optional Standard I/O board is present.
215
Last Stop Source
Range:
0 = Pwr Removed
1 = DPI Port 1
2 = DPI Port 2
3 = DPI Port 3
4 = DPI Port 4
5 = DPI Port 5
6 = DPI Port 6 (Frame 4 only)
7 = Digital In
8 = Fault
9 = Not Enabled
10 = Sleep
11 = Jog
Default:
Read Only
Access:
1
Path: Utility > Diagnostics
See also:
216
Dig In Status
Range:
See
Default:
Read Only
Access:
0
Path: Utility > Diagnostics
See also:
361...366
0
0
0
0
0
0
x
x
x
x
x
x
x
x
x
x
0
0
1
1
2
3
4
5
6
7
8
9
11
12
13
14
15
1 =Input Active
0 =Input Not Active
x =Reserved
Bit #
Digital In1
Digital In2
Digital In3
Digital In4
Digital In5
Digital In6
Nibble 1
Nibble 2
Nibble 3
Nibble 4