Figure 30, Figure 31 – Rockwell Automation Liqui-Flo V2.0 AC Drive User Manual
Page 75
Rockwell Automation Publication D2-3518-3 - May 2013
75
Chapter 9
Figure 30 - Appl Digital Output (30) Frame 3
Frame 4 drives (firmware version 2.x) only:
The lower byte of this parameter controls the state of the shunt trip digital output
and the six application controlled digital outputs on the Combined I/O board.
The upper byte controls the operation of the rectifier when configured for
manual operation.
Figure 31 - Appl Digital Output (30) Frame 4
In addition to controlling digital output 3, bit 1 is also used to force the Aux Run
digital output condition to true. This only occurs if the Digital Out Sel
parameter for one of the user-configurable digital outputs is set to Aux Run.
The value entered into this parameter is output on the analog output when it is
configured for Application control. See parameter Analog Out1 Sel (342).
31
Appl Analog Out
Range:
-32.767...32.767 [0.001 mA, or 0.001V (frame 4 only)]
Default:
See
below.
Access:
1
Path: Monitor > Application
See also:
342, 343, 344
0
0
0
0
0
0
x
x
0
0
x
x
x
x
x
x
0
0
1
1
2
3
4
5
6
7
8
9
11
12
13
14
15
1 =Active
0 =Inactive
x =Reserved
Bit #
Factory Default Bit Values
AC Line I/O Dig. Output 1
AC Line I/O Dig. Output 2
AC Line I/O Dig. Output 3
AC L
ine I/O Dig
. Output 4
AC Line
I/O Dig. Output 5
AC L
ine I/O Di
g. Output
6
Close Pre-c
harge
Enab
le Rectifier
Nibble 1
Nibble 2
Nibble 3
Nibble 4
0
0
0
0
0
x
x
x
x
x
0
0
1
1
2
3
4
5
6
7
8
9
11
12
13
14
15
1 =Active
0 =Inactive
x =Reserved
Bit #
Shunt tr
ip
Comb. I/O Dig. Output 3
Comb. I/O Dig. Ou
tput 4
Comb. I/O Dig. Ou
tput 5
Comb. I/O Dig. Ou
tput 6
Comb. I/O Dig. Output 7
Comb. I/O Dig. Output 8
Nibble 1
Nibble 2
Nibble 3
Nibble 4
0
0
x
x
Close Pre-charge
Enab
le Rectifier
0
0
Powerup Default Bit Values