Rockwell Automation Liqui-Flo V2.0 AC Drive - Manual (Page 78)

78 Rockwell Automation Publication D2-3518-3 - May 2013
Chapter 9
The actual state of the rectifier.
Frame 3 drives (firmware version 1.x) only:
Figure 34 - Rectifier Status (34) Frame 3
Frame 4 drives (firmware version 2.x) only:
Figure 35 - Rectifier Status (34) Frame 4
34 Rctfr Status
Range: See Figure 34 and Figure 35
Default: N/A
Access: 1 Path: Monitor > Application
See also: rectifier 101
IMPORTANT This parameter is used for communication between the inverter and the
rectifier. Do not write to this parameter using VS Utilities, DriveExplorer, or an
OIM. Its value changes according to the operational state of the drive.
x x x x
0 0 1 1 2 3 4 5 6 7 8 9 11 12 13 14 15
x =Reserved
Bit #
OK to Run I
nverter
Rectifier Running Rectifier F
aulted
Rectifier in Limit Rectifier Synch
roniz
ed
Rectifier Phased ACB Rectifier at
V
oltage
Rectifier Regener
ating
Fault Reset Echo
Nibble 1 Nibble 2 Nibble 3 Nibble 4
Rectifier Carrier Sync Bit 0 Indicates OK to Run Standb
y
x
0 0 1 1 2 3 4 5 6 7 8 9 11 12 13 14 15
x =Reserved
Bit #
OK to Run I
nverter
Rectifier Running Rectifier F
aulted
Rectifier in Limit Rectifier Synch
roniz
ed
Rectifier Phased ACB Rectifier at
V
oltage
Rectifier Regener
ating
Fault Reset Echo
Nibble 1 Nibble 2 Nibble 3 Nibble 4
Rectifier Carrier Sync Loop Control Enable Appl. Digital Out 3 Bit 0 indicates OK to
run
Appl. Digital Out 4 Standb
y