Rockwell Automation Liqui-Flo V2.0 AC Drive - Manual (Page 246)

246 Rockwell Automation Publication D2-3518-3 - May 2013
Appendix B
Setting the Display Timeout Period
When the OIM is inactive (that is, no keys have been pressed) for a user-specified
period of time, the process display screen becomes active. To return to the
previously active screen, press any key. To return to the Main Menu, press
.
To set the display timeout period, select Display Timeout from the Display
menu. The timeout period can range from 10...1200 seconds (20 minutes).
This feature can also be disabled by pressing the F1 key while in the display time
screen.
Note that each OIM connected to the drive can have a different timeout period.
Using Reverse Video for the Process Display Screen
To select normal or reverse video for the process display screen, select Display
Video from the Display menu. See
Figure 102 for sample screens.
Note that each OIM connected to the drive can have a different display mode.
Figure 102 - Selecting Reverse Video for the Process Display Screen
Controlling the Drive From
the OIM The OIM can be used to control the drive:
• Start (Run)
• Stop
• Clear Faults
Starting the Drive
When start from the OIM is enabled using the Logic Mask (276) and Start Mask
(277), pressing
issues a start command to the drive.
Stopping the Drive
Pressing issues a stop command to the drive.
ESC/
PROG
P0: LiquiFlo 2.0
Auto Stopped
Fltq
0.00 V olts
A m ps
H z
0.00
0.00
Luse1
Normal Video Reverse Video
P0: LiquiFlo 2.0
Auto Stopped
Fltq
0.00 V olts
A m ps
H z
0.00
0.00
Luse1
IMPORTANT Stop commands from any attached OIM are always enabled.