Rockwell Automation Liqui-Flo V2.0 AC Drive - Manual (Page 129)

Rockwell Automation Publication D2-3518-3 - May 2013 129
Chapter 9
Enables/disables annunciation of the faults shown in Figure 57 .
Figure 57 - Fault Config 1 (238)
Resets a fault and clears the fault queue. After the fault clear operation is
complete, this parameter returns to the value of 0 for Ready.
Enables/disables a fault reset (clear faults) attempt from any source.
Accumulated hours that inverter had been powered up at the time of the most
recent drive powerup.
238 Fault Config 1
Range: See Figure 57
Default: See Figure 57
Access: 0 Path: Utility > Faults
See also:
240 Fault Clear
Range: 0 = Ready
1 = Clear Faults
2 = Clr Flt Que
Default: 0 = Ready
Access: 1 Path: Utility > Faults
See also:
241 Fault Clear Mode
Range: 0 = Disabled
1 = Enabled
Default: 1 = Enabled
Access: 1 Path: Utility > Faults
See also:
242 Power Up Marker
Range: 0.0000...4,294,967.2925 Hr [0.0001 Hr]
Default: Read Only
Access: 1 Path: Utility > Faults
See also: 244, 246, 248, 250, 252, 254, 256, 258
1 x 1 1 0 0 0 x x x x x x x x x
0 0 1 1 2 3 4 5 6 7 8 9 11 12 13 14 15
1 =Enabled
0 =Disabled
x =Reserved
Bit #
Factory Default Bit Values
Po
w
er Loss
Und
erV
oltage
Motor Ov
erLd
Shear Pin Au
tRst T
ries
Decel
Inhibit
Nibble 1 Nibble 2 Nibble 3 Nibble 4
32