Guralp Systems Scream - Manual (Page 128)

Scream! 4.5
11.2 E-mail notification
You can also instruct Scream! to send e-mail to warn the operator
when particular events happen. To set this up, choose File Setup…
→
from the main menu and move to the Email Options tab.
To be able to use e-mail, you will need access to a mail (SMTP) server
which will accept messages from the address
Scream_SMTP_client@your-hostname. Fill in the IP address or
hostname of this server in the SMTP Server box. Enter in the
Recipient box the e-mail address to which you want the mail sent.
The events you can monitor are:
Digitiser re-boots : Scream! can recognise the boot-up status messages
of a Güralp digitiser or digital instrument. These are normal after a
power cycle, or when a new configuration is uploaded to the digitiser.
After a re-boot, you should receive Re-Sync and Data Discontinuity
messages as well.
Re-Syncs : Whenever the digitiser's internal clock is resynchronized
with GPS. These are normal after a re-boot, or an extended period of
GPS outage.
Data Discontinuities : Any detected gap in a stream, along with the
reason, if known. This includes reboots, clock syncs, and intentional
gaps in triggered channels, as well as data lost owing to slow or
poor-quality communications links. You should check the log files
(see above) to help you determine the cause.
SAM disk full : SAM units send status messages when they stop
recording data because their disk is full. SAM units in circular-buffer
128 Issue K