Hypertherm Powermax125 Service Manua - Manual (Page 174)

174 Powermax125 Service Manual 808070
9 – Power Supply Component Replacement
Replacing the end panel bracket
Remove the end panel bracket
1. Complete the following procedures:
a. See Disconnect the power and gas supply on page 166.
b. See Remove the power supply cover on page 172.
c. See Remove the component barrier on page 173.
2. Remove the 2 mounting screws from the end panel bracket .
3. Lift the end panel bracket straight up from the power supply.
Figure 41
1 2
1
2