Finecut shielded with ohmic consumables, Install the machine torch consumables, Aligning the torch – Hypertherm Powermax125 Service Manua User Manual
Page 75
Powermax125 Service Manual 808070
75
6 – Machine Torch Setup
FineCut shielded with ohmic consumables
Install the machine torch consumables
To operate the machine torch, a complete set of consumable parts must be installed: shield, retaining cap, nozzle,
electrode, and swirl ring.
With the power switch in the OFF (O) position, install the machine torch consumables in a manner similar to the hand
torch consumables. See
Aligning the torch
Mount the machine torch perpendicular to the workpiece in order to get a vertical cut. Use a square to align the torch at
right angles to the workpiece.
Position the mounting bracket as low on the torch as possible to minimize vibration at the
tip of the torch.
WARNING!
INSTANT-ON TORCHES
PLASMA ARC CAN CAUSE INJURY AND BURNS
The plasma arc comes on immediately when the torch trigger is activated. Make sure the
power is OFF before changing consumables.
420152
Shield
420156
Ohmic-sensing
retaining cap
420151
Nozzle
220971
Electrode
220997
Swirl ring
Mounting bracket