NavCom SF-2040 Rev.C - Manual (Page 112)

LAND-PAK™ User Guide – Rev. C
5-108
2. Aft tatic
Dat e next
sec
GPS R
1. Do
2. Dis e GPS.
a. coiled
•
er completing the steps in the Collect S
a section of Appendix D, continue to th
tion, GPS Rover Setup.
over Setup
not exit SurvCE.
connect the Explorer 600+ from the bas
Remove the LEMO 7-Pin end of the
serial cable (see Figure 51) from COM1
Do not remove the female 9-pin serial
connector end of the cable from the E
600+.
Connect the Explorer 600+ to the rover GPS.
.
xplorer
3.
a. Connect the LEMO 7-Pin end of the coiled
serial cable to COM1 of the rover GPS.
Figure 72: Equip Menu – GPS Rover
4. Sel GPS
). The
GPS Rover submenu opens (see Figure 73). It
has four tabs similar to the GPS Base submenu.
ect Equip > GPS Rover to configure the
Rover for RTK/Static surveys (see Figure 72