NavCom SF-2040 Rev.C - Manual (Page 73)

LAND-PAK™ User Guide – Rev. C
4-69
3. Press the down
down the main menu to
arrow soft key to move the cursor
Sig. Threshold.
using SurvCE and should cause optimum
performance.
5. Press the Set soft key to set the threshold level.
The display returns to the submenu with the
cursor at TX level.
ss the Back soft key to return to the main
everything set to Off.
Serial Port Settings
1. Press the down arrow soft key to move the cursor
down the main menu to Port 1 (see igu
4. Press the Change soft key to change the Signal
Threshold level. A submenu is displayed with
available negative dBm settings.
a. Set the threshold to -116dBm.
• This is equivalent to the Low threshold set
6. Pre
me
Addressing Settings
The Addressing remains at factory default with
nu.
F re 28).
Figure 28: Main Menu – Port 1 Setting
2.
b
sta
the def
Press the Select soft key to select
su menu is displayed. The cursor po
Port 1. A
ints to the
tus of Port 1. The default is ON. Do not change
ault.