NavCom SF-2040 Rev.C - Manual (Page 55)

LAND-PAK™ User Guide – Rev. C
3ASd and 3ASd 869 Radio Modem Battery
A 9.6V 2Ah NiMh battery powers both the 3ASd and
the 3ASd 869 radio modems. The battery is attached
to a cradle on the back of the radios. The battery
charger is the same for both types of radio modem.
The LAND-PAK LM configuration includes one
battery charger
1
for the 3ASd radio modem (rover).
The LAND-PAK 869 configuration includes two
battery chargers
1
, one for each 3ASd 869 radio
modem (base and rover).
There is no charging indicator on the battery charger.
The top of the battery has an on/off switch and a red
LED. The illuminated red LED indicates power on and
battery charging.
Charge the batteries only with the
supplied battery charger; otherwise,
damage to the battery could occur.
„ Battery
LED
Table 9: Rover Radio Modem Battery LED
LED Status
Battery Charging/Radio Modem Power On
„ Battery
Charging
Refer to Figure 9, item 4 for battery charger photo.
1. Connect the serial 9-pin end of the battery
charger to the female connector on the bottom of
the radio.
2. Plug the opposite end of the battery charger into
an AC receptacle.
1
Battery Charger Option:
110V (P/N 59-800001-0001) or 220V (P/N 59-800001-0002)
4-51