NavCom SF-2040 Rev.C - Manual (Page 68)

LAND-PAK™ User Guide – Rev. C
4-64
top of th
illuminat e battery. The red LED
es.
‡
During this initial configuration, the
signal strength setting in data transfer
mode is blank (see Figure 19).
Figure 19: Data Transfer Mode
programming mode. Press the Setup soft
e 2. Acc ss
key e
sho
ver n
app r
‡
RF requ
e
(s
ws
sio lly
ea s (see Figure 18).
any time during configuration, press
Cancel/Back
Figure 19). The display temporarily
the radio modem model and the firmware
. Then the main menu automatica
At
the
soft ke
changes if necessary, t
previous scr
y to cancel
o return to a
een, or to exit the main
menu.
ency Configuration F
nly to a
licensed frequency. It must comply
with local regulations.
A label on both radios lists the i
Set the radio modems o
‡
nitial
(center) frequency. The label is on the
front of the base station radio. It is on
the rear of the rover radio, above the
battery. The frequency can be set
within 1MHz of the center frequency,
at 25KHz increments.