NavCom SF-2040 Rev.C - Manual (Page 172)

LAND-PAK™ User Guide – Rev. C
C-168
5. Tap the Continue Last Job button or the Select
New/Existing Job button.
• If
the Continue Last Job button is tapped, a
connection is established. If the Select
New/Existing Job button is tapped, the
Coordinate Files window opens. For
instructions on setting up a new job, refer to
the Create A New Job
• section in Chapter 5 SurvCE Software
Operation.
6. Select is Equip > GPS Rover. A connection
established. The GPS Rover window opens.
7. Tap the Comms tab.
8. In the Baud drop-down list, select 19200 (see
Figure 121).
Figure 121: TruBlu Baud Rate Setting
9. Tap to accept the setting and connect to the
GPS sensor. A connection is established.
10. Remove the serial cable from the SF-2040 GPS
sensor and the Explorer 600+. Do not exit SurvCE
on the Explorer 600+.
11. Insert TruBlu in COM1 of the SF-2040. The red
lue. dot on TruBlu must face up. TruBlu blinks b