NavCom SF-2040 Rev.C - Manual (Page 89)

LAND-PAK™ User Guide – Rev. C
4-85
Refer to Figure 46 for the steps below:
6. Adjust the rover pole and bipod assembly:
a. Pivot the bipod legs out.
b. Adjust the height of the bipod legs. With the
leg points on the floor or ground, press the
bipod thumb releases and lift up. At the
desired height, release the thumb releases.
If the bipod legs are suspended when
the thumb releases are pressed, the
l
legs drop quickly, and the leg points
may cause damage.
c. Adjust the rover pole and bipod assembly un
it is stable. It
ti
does not have to be level.
Figure 47: Mounting the Carlson Explorer 600+
Refer to Figure 47 for the steps below:
7. Mount the cradle for the Carlson Explorer 600+:
• Loosen the knob on the small cradle clamp.
• Mount the small cradle clamp to the carbon
fiber section of the rover pole, near the top
bracket. The rover setup is mo stable if the
re