NavCom SF-2040 Rev.C - Manual (Page 86)

LAND-PAK™ User Guide – Rev. C
4-82
COM2
Figure 44: NavCom Base Cable Connections
Refer to Figure 44 for the steps below:
. Connect the NavCom se cable (the L ND-PAK
in end of the cable to
ctor on the bottom
.
n end of the cable to
GIS PM Sensor.
connector end
in this
‡
figuration:
cable to
3ASd 869 radio modem to
COM 2 of the SF-2040 GIS PM
Sensor.
22. This concludes
Carefully, disassemble t
repack all the equipment into the base transit
case and base bag.
21
•
ba A
LM configuration):
Connect the serial 15-P
the female serial conne
right of the radio modem
• Connect the LEMO 7-
COM 2 of the SF-2040
Pi
‡
The LEMO 2-Pin power
of the cable is not used
procedure.
The LAND-PAK 869 con
Use the NavCom DB-9
connect the
the base station test setup.
he base station, and