NavCom SF-2040 Rev.C - Manual (Page 59)

LAND-PAK™ User Guide – Rev. C
„ Battery
Charging
‡
The battery pack is shipped fully
charged and installed in the Explorer
600+. Some battery dissipation occurs
during shipping. Charge the battery
pack in the Explorer 600+ for
approximately four hours before first
use.
1. Assemble the battery charger kit:
a. Fit the input plug into the AC/DC adapter (see
Figure 12).
Figure 12: AC/DC Adapter Input Plug
b. Plug the battery charger jack into the rear
power connector on the female connector end
of the charging cable (see Figure 13).
Figure 13: Battery Charger/Charging Cable
2. Connect the female connector end of the charging
cable to the 9-pin male connector on the bottom
of the Explorer 600+ (see Figure 14).
4-55