NavCom SF-2040 Rev.C - Manual (Page 51)

LAND-PAK™ User Guide – Rev. C
If the battery packs are left charging
for longer than 5 days, the charging
indicator LEDs will shut off. If this
occurs, place the battery packs in the
SF-2040 GPS Sensor and power on
for 10-15 minutes in order to slightly
discharge the batteries.
Remove the battery packs from both
SF-2040 GPS Sensors if the sensors
will not be used for over 1 week.
„ Battery
Installation
The SF-2040 GPS Sensor battery packs are keyed to
prevent improper installation. There are two locking
clips on either side of the battery end (see Figure 10).
Figure 10: Battery Locking Clips
The bottom of the sensor has two battery chambers.
Install each battery pack by sliding it into a chamber.
Align the channel on the chamber to match the
battery notch. Press the end firmly until the locking
clips click. Verify both locking clips are locked in
place.
If both locking clips are not locked in
place, a battery pack could
inadvertently drop to the ground.
4-47