NavCom SF-2040 Rev.C - Manual (Page 50)

LAND-PAK™ User Guide – Rev. C
„ Battery Charger LEDs
Table 7: Sensor Battery Charger LEDs
LED Status
Power
Power On
Battery Bays
Charging
Charging Complete
„ Battery
Charging
‡
The SF-2040 battery packs are
shipped in a partially charged state.
Complete one full charge cycle (8-10
hours) before battery use.
Refer to Figure 9, item 1 for battery charger kit photo.
1. Connect the power cable to the AC to DC power
supply.
2. Connect the power supply jack to the battery
charger assembly.
3. Plug the power cable into an AC receptacle. The
green power LED illuminates.
4. Insert four battery packs into the charger. The
LED status is shown in Table 7.
5. Charge battery packs until the green LED below
each bay illuminates.
Do not short circuit battery contacts.
Do not store battery packs above 60
deg C (140 deg F). Do not
disassemble battery packs. Do not
expose to fire (explosive hazard).
4-46