NavCom SF-2040 Rev.C - Manual (Page 98)

LAND-PAK™ User Guide – Rev. C
5-94
2. Check the Prompt for Units option to be prom
at the start of a new job to set the units for the job
(see Figure 56
pted
).
Submenu – New Job Tab Figure 56: Job Settings
Figure 57 for the steps below: Refer to
3. Tap the System tab.
Figure 57: Job Settings Submenu – System Tab
4. Select the appropriate settings:
• Distance: Set the units to be used on a job,
US Feet, International Feet, or Metric. If US
Feet or International Feet are selected, set the
units as Decimal Feet or Feet and Inches
(Inches).