NavCom SF-2040 Rev.C - Manual (Page 80)

LAND-PAK™ User Guide – Rev. C
4-76
Use the two Allen wrenches (4mm and/or 5mm,
respectively) on the top plate of the tripod to
tighten the hex screws at the top of the tripod if
needed.
5. Store the two Allen wrenches in the
and discard
base bag,
the protective paper cover.
Figure 37: Mounting Tribrach & Tribrach Adapter
Refer to Figure 37 for the steps below:
6. Mount the tribrach to the top of the tripod as
follows:
• Position the tribrach so it fits evenly on the top
plate and is flat.
• Screw the tribrach fastener into the tribrach
until it is secure.
‡
The tribrach has a leveling bubble a
down the knob on the side of the tribrach.
nd
7. Mount the tribrach adapter into the three holes of
the tribrach, and then lock it in place by turning
three adjustment knobs to make fine
adjustments.