NavCom SF-2040 Rev.C - Manual (Page 54)

LAND-PAK™ User Guide – Rev. C
4. Unplug the battery charger.
Male 15-Pin
Serial
Connector
LEMO 2-Pin
Connector
LEMO 7-Pin
Connector
Figure 11: NavCom Base Cable
Refer to Figure 11 for the steps below:
5. Verify the bag battery is fully charged. Power on
the radio modem to check the battery voltage:
a. Connect the serial 15-pin end of the NavCom
base cable to the female serial connector on
the bottom right of the radio modem.
b. Connect the LEMO 2-pin end of the base
cable to the bag battery. The radio modem
powers on. (The LEMO 2-pin connector is
fitted to the red fuse-fit and black cables.)
The LCD display shows the battery status and
other settings. The supply voltage is in the top
right (see Figure 17). A full charge is 13.5V to
14.70V.
‡
The LEMO 7-Pin end of the base
cable is not used in this procedure.
6. Disconnect the bag battery if it is fully charged.
4-50