NavCom SF-2040 Rev.C - Manual (Page 87)

LAND-PAK™ User Guide – Rev. C
4-83
Rover Test Setup
This section provides the steps to correctly and safely
set up the rover. It is important to select an open area
for the test setup.
An outdoor setup requires the transport of the rover
transit case and the rover bag, both of which contain
all the rover equipment.
‡
The outer section of the rover pole is
carbon fiber. The inner extension is
aluminum, with dual graduations in
feet and meters.
The rover pole and bipod leg points
may damage so
ft materials, including
indoor carpets.
Over tightening attachment
carbon fiber of the rover pole may s to the
cause damage.
The bipod is intended to make
installation easier, but it is not as
stable as a tripod.
d a safe, 1. Fi open, and flat location to setup the
rover.
lowing steps use equipment from the rover
n
d
3.
gs.
The fol
bag:
2. Remove the strap that holds together the bipo
legs. Store the strap in the rover bag.
Position the bipod upright on the floor or ground.
Do not open the bipod le