NavCom SF-2040 Rev.C - Manual (Page 119)

LAND-PAK™ User Guide – Rev. C
5-115
Refer to Figure 79 for the options below:
2. Select an option, as necessary:
• Configure RTK Device: Configure the power,
channel and squelch on the Satel radio
modem (see Figure 68). This option is the
same as RTK Configure in the base and rover
setups above.
• Check RTK: Determine if the receiver is
operating properly. If there is problem, a
message is displayed.
0
of the
e as cycling the
ars:
o the
•
Qu
Quickstart (StarFire™ Only): Perform a
ickstart from a previously saved ITRF 200
position.
‡
Starfire™ corrections often take some
time to acquire high levels of
accuracy. If the user plans to return to
a previously surveye
can save time by storing a known
d area, the user
position to a reference file (*.ref). Then
the user can initialize the Starfire
system with this position upon
returning to the site by performing a
Quickstart.
• Reset Receiver: Perform a soft reset
GPS receiver. This is the sam
front panel power switch.
• Factory Reset: Reset the GPS receiver to
factory defaults. A warning message appe
“Drastic measure, will take 15 minutes to
recover.”
Power On Receiver: Does not apply t
NavCom SF-2040 receiver.
•
3. Continue to the next section.