NavCom SF-2040 Rev.C - Manual (Page 116)

LAND-PAK™ User Guide – Rev. C
5-112
Refer to Figure 76 for the steps below:
9. Tap the RTK tab.
Figure 76: GPS Rover Submenu – RTK Tab
10. Set the options:
• Device: Satel
• Baud: 38400
• Base ID: If a Base ID is assigned to
station, enter the exact same ID, or
will not receive transmissions.
Use Any Base ID: If desired, check th
to permit the rover radio modem to rec
communications from any available ba
is transmitting on the same frequency.
p the
the base
the rover
•
is option
eive
se that
11. Ta button on the RTK tab.
12.
g
v
e
t
The Configure Satel Radio window opens (see
Fi ure 77). Set the Channel frequency for the
er radio modem as needed. Set the Squelch to
dium or High to maintain the best correction
a integrity. ro
M
da
‡
Do not change the RF power output,
as the rover is not transmitting.