H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 116)

103
Adding rules to an SNMP view
1. Select Device > SNMP from the navigation tree.
2. Click the View tab.
The page in
Figure 81 appears.
3. Click the icon of the target view.
The Add rule for the view ViewDefault window appears.
Figure 84 Add rules to an SNMP view
4. Configure the parameters as described in Table 34 .
5. Click Apply.
NOTE:
You can also click the icon corresponding to the specified view on the page as shown in Figure 81 ,
and then you can enter the page to modify the view. Figure 84
Configuring an SNMP community
1. Select Device > SNMP from the navigation tree.
2. Click the Community tab.
The Community tab page appears.
Figure 85 Configure an SNMP community
3. Click Add.