H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 261)

248
Figure 223 Configure a default route
Verifying the configuration
1. Display the route table:
Enter the IPv6 route page of Switch A, Switch B, and Switch C respectively to verify that the newly
configured static routes are displayed as active routes on the page.
2. Use the ping command for verification:
Ping Host B from Switch A.
<SwitchA> system-view
[SwitchA] ping ipv6 3::2
PING 3::2 : 56 data bytes, press CTRL_C to break
Reply from 3::2
bytes=56 Sequence=1 hop limit=254 time = 63 ms
Reply from 3::2
bytes=56 Sequence=2 hop limit=254 time = 62 ms
Reply from 3::2
bytes=56 Sequence=3 hop limit=254 time = 62 ms
Reply from 3::2
bytes=56 Sequence=4 hop limit=254 time = 63 ms
Reply from 3::2
bytes=56 Sequence=5 hop limit=254 time = 63 ms
--- 3::2 ping statistics ---
5 packet(s) transmitted