Link aggregation and lacp configuration example, Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 194
181
Field Description
Partner Port State
State information of the peer port, represented by letters A through H.
•
A indicates that LACP is enabled.
•
B indicates that LACP short timeout has occurred. If B does not appear, it indicates that
LACP long timeout has occurred.
•
C indicates that the link is considered aggregatable by the sending system.
•
D indicates that the link is considered as synchronized by the sending system.
•
E indicates that the sending system considers that collection of incoming frames is
enabled on the link.
•
F indicates that the sending system considers that distribution of outgoing frames is
enabled on the link.
•
G indicates that the receive state machine of the sending system is using the default
operational partner information.
•
H indicates that the receive state machine of the sending system is in the expired state.
Oper Key
Operational key of the local port.
Table 60 Field description in the Partner Port Details table
Field Description
Unit
Number of the remote system.
Port
Name of the remote port.
Partner ID
LACP priority and MAC address of the remote system.
Partner Port Priority
LACP priority of the remote port.
Partner Oper Key
Operational key of the remote port.
Link aggregation and LACP configuration example
Network requirements
As shown in
, aggregate the ports on each device to form a link aggregation group, balancing
incoming/outgoing traffic across the member ports.
Figure 162 Network diagram
You can create a static or dynamic link aggregation group to achieve load balancing.