H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 401)

388
Item Description
Aggregation port
• On the switch engine of a WX3000E series wireless switch, ports
GigabitEthernet 1/0/29 and GigabitEthernet 1/0/30 are aggregated to
BAGG 1.
• On the control engine of a WX3000E series wireless switch, ports
GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 are aggregated to BAGG
1.
Port isolation configuration example
Network requirements
As shown in Figure 384 :
• Campus network users Host A, Host B, and Host C are connected to GigabitEthernet 1/0/2,
GigabitEthernet 1/0/3, and GigabitEthernet 1/0/4 of Switch.
• Switch is connected to the external network through GigabitEthernet 1/0/1.
• GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, GigabitEthernet 1/0/3, and GigabitEthernet
1/0/4 belong to the same VLAN.
It is required that Host A, Host B, and Host C can access the external network while being isolated from
one another on Layer 2.
Figure 384 Networking diagram
Configuring port isolation
1. Add port isolation group 1:
a. Select Security > Port Isolate Group from the navigation tree.
b. Click the Group Setup tab to enter the page shown in Figure 385 .
c. Enter 1 in the Isolate group ID field.
d. Click Apply.