H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 214)

201
Figure 175 Network diagram
Configuring Switch A
1. Enable LLDP on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2. (Optional. By default, LLDP is
enabled on Ethernet ports.)
2. Set the LLDP operating mode to Rx on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2:
a. Select Network > LLDP from the navigation tree to enter the Port Setup tab, as shown in Figure
176 .
b. Select ports GigabitEthernet1/0/1 and GigabitEthernet1/0/2.
c. Click Modify Selected.
The page shown in
Figure 177 appears.