Setting lacp priority, Figure 159 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 191
178
Figure 159 Display information of an aggregate interface
Table 57 Field description
Field Description
Aggregation interface
Type and ID of the aggregate interface.
Bridge-Aggregation indicates a Layer 2 aggregate interface.
Link Type
Type of the aggregate interface, which can be static or dynamic.
Partner ID
ID of the remote device, including its LACP priority and MAC address.
Selected Ports
Number of Selected ports in each link aggregation group (Only Selected ports
can transmit and receive user data).
Standby Ports
Number of Unselected ports in each link aggregation group (Unselected ports
cannot transmit or receive user data).
Member Port
A member port of the link aggregation group corresponding to the selected
aggregate interface.
State
Select state of a member port, Selected or Unselected.
Reason for being Unselected
Reason why the state of a member port is Unselected. For a selected member
port, this field is displayed as "-".
Setting LACP priority
1.
Select Network > LACP from the navigation tree.
2.
Click the Setup tab to enter the page shown in