H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 294)

281
Diagnostic tools
Overview
Ping
You can use the ping function to check whether a device with a specified address is reachable, and to
examine network connectivity.
A successful execution of the ping command involves the following steps:
1. The source device sends an ICMP echo request (ECHO-REQUEST) to the destination device.
2. The destination device responds by sending an ICMP echo reply (ECHO-REPLY) to the source
device after receiving the ICMP echo request.
3. The source device displays related statistics after receiving the reply.
Output of the ping command falls into the following:
• You can ping the IP address or the host name of the destination device. If the target host name
cannot be identified, the source device outputs related information.
• If the source device does not receive an ICMP echo reply within the timeout time, it displays the
prompt information and the statistics during the ping operation. If the source device receives an
ICMP echo reply within the timeout time, it displays the number of bytes of the echo reply, the
message sequence number, Time to Live (TTL), the response time, and the statistics during the ping
operation.
Statistics during the ping operation include number of packets sent, number of echo reply messages
received, percentage of messages not received, and the minimum, average, and maximum response
time.
Trace route
By using the trace route command, you can display the Layer 3 devices involved in delivering a packet
from source to destination. This function is useful for identification of failed node(s) in the event of network
failure.
You can trace route the IP address or the host name of the destination device. If the target host name
cannot be identified, the source device outputs related information.
The trace route command involves the following steps in its execution:
1. The source device sends a packet with a TTL value of 1 to the destination device.
2. The first hop (the Layer 3 device that first receives the packet) responds by sending a TTL-expired
ICMP message to the source, with its IP address encapsulated. In this way, the source device can
get the address of the first Layer 3 device.
3. The source device sends a packet with a TTL value of 2 to the destination device.
4. The second hop responds with a TTL-expired ICMP message, which gives the source device the
address of the second Layer 3 device.