Configuration guidelines – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 262

Advertising
background image

249

5 packet(s) received

0.00% packet loss

round-trip min/avg/max = 62/62/63 ms

Configuration guidelines

When you configure a static route, follow these guidelines:

If you do not specify the preference when you configure a static route, the default preference will be
used. Reconfiguration of the default preference applies only to newly created static routes. Currently,
the Web interface does not support configuration of the default preference.

When you configure a static route, the static route does not take effect if you specify the next hop
address first and then configure it as the IP address of a local interface, such as a VLAN interface.

When specifying the output interface, note that:

{

If NULL 0 or a loopback interface is specified as the output interface, there is no need to
configure the next hop address.

{

If a point-to-point interface is specified as the output interface, you don’t need to specify the next
hop, and there is no need to change the configuration after the peer address has changed. For

example, a PPP interface obtains the peer’s IP address through PPP negotiation, and therefore

you only need to specify it as the output interface.

{

If the output interface is an NBMA or P2MP interface, which supports point-to-multipoint

networks, the IP address-to-link layer address mapping must be established. Therefore, you are
recommended to specify the next hop IP address when you configure it as the output interface.

{

If you want to specify a broadcast interface (such as a VLAN interface) as the output interface,
which may have multiple next hops, you need to specify the next hop at the same time.

You can delete only IPv4/IPv6 static routes on the Remove tab.

Advertising