PLANET XGS3-24042 - Manual (Page 1076)

60-15
Switch(config)# router vrrp 10
60.10 show vrrp
Commands:
show vrrp [<vrid>]
Function:
Displays status and configuration information for the VRRP standby cluster.
Parameters:
< vrid > is the Virtual Router number ranging from 1 to 255.
Command mode:
Admin and Configuration Mode.
Usage Guide:
This command is used to display the Virtual Router configuration and current state. If not specified
the Virtual Router number, then display all Virtual Router information.
Example:
Switch# show vrrp
VrId <1>
State is Initialize
Virtual IP is 10.1.20.10 (Not IP owner)
Interface is Vlan1
Priority not configured, Current priority is 254
Advertisement interval is 1 sec
Preempt mode is TRUE
Circuit failover interface Vlan1, Priority Delta 1, Status UP
VrId <10>
State is Initialize
Virtual IP is1.1.1.1 (Not IP owner)
Interface is unset
Priority is unset
Advertisement interval is unset
Preempt mode is TRUE
Switch#
Displayed information Explanation
State Status