PLANET XGS3-24042 - Manual (Page 527)

33-166
33.40 show ip rip aggregate
Command:
show ip rip aggregate
Function:
To display the information of IPv4 aggregation route.
Command Mode:
Admin and Configuration Mode.
Usage Guide:
This command is used to display which interface the aggregation route be configured, Metric, Count,
Suppress and so on. If configured under global mode, then the interface display “----”, “Metric” is
metric. “Count” is the number of learned aggregation routes. “Suppress” is the times of aggregation.
Example:
To display the information of IPv4 aggregation route.
Switch(Config-if-Vlan1)#show ip rip agg
Aggregate information of rip
Network Aggregated Ifname Metric Count Suppress
192.168.0.0/16 Vlan1 1 2 0
192.168.4.0/22 ---- 1 2 0
192.168.4.0/24 ---- 1 1 1
Vlan1 1 1 1
Displayed information Explaination
Network Route prefix and prefix length.
Aggregated Ifname To configure the interface name of the aggregation route. If the route
aggregated globally, then display “----”.
Metric Metric of aggregation route.
Count The number of learned aggregation route.
Suppress The times of aggregated for aggregation route.
33.41 timers basic
Command:
timers basic <update> <invalid> <garbage>
no timers basic