PLANET XGS3-24042 - Manual (Page 394)

26-33
If client node type is to be specified, it is recommended to set the client node type to h-node that
broadcasts after point-to-point communication.
Example:
Setting the node type for client of pool 1 to broadcasting node.
Switch(dhcp-1-config)#netbios-node-type b-node
26.1.23 network-address
Command:
network-address <network-number> [<mask> | <prefix-length>]
no network-address
Function:
Sets the scope for assignment for addresses in the pool; the “no network-address” command
cancels the setting.
Parameters:
<network-number> is the network number;
<mask> is the subnet mask in the decimal format;
<prefix-length> stands for mask in prefix form. For example, mask 255.255.255.0 in prefix is “24”,
and mask 255.255.255.252 in prefix is “30”. Note: When using DHCP server, the pool mask should
be longer or equal to that of layer 3 interface IP address in the corresponding segment.
Default:
If no mask is specified, default mask will be assigned according to the address class.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
This command sets the scope of addresses that can be used for dynamic assignment by the DHCP
server; one address pool can only have one corresponding segment. This command is exclusive
with the manual address binding command “hardware address” and “host”.
Example:
Configuring the assignable address in pool 1 to be 10.1.128.0/24.
Switch(dhcp-1-config)#network-address 10.1.128.0 24
26.1.24 next-server
Command:
next-server <address1>[<address2>[…<address8>]]