PLANET XGS3-24042 - Manual (Page 888)

45-33
Switch(Config-if-Vlan2)#ipv6 pim scope-border 503
45.3.32 ipv6 pim sparse-mode
Command:
ipv6 pim sparse-mode [passive]
no ipv6 pim sparse-mode [passive]
Function:
Enable PIM-SM on the interface. no ipv6 pim sparse-mode [passive] disables PIM-SM.
Parameter:
[passive] means to disable PIM-SM (that’s PIM-SM doesn’t receive any packets) and only enable
MLD(reveice and transmit MLD packets).
Default:
Disabled PIM-SM
Command Mode:
Interface Configuration Mode
Usage Guide:
Enable PIM-SM on the interface. The command can configure on IPv6 tunnel interface, but it is
successful configuration to only configure tunnel carefully.
Example:
Enable PIM-SM on the interface vlan1.
Switch (config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 pim sparse-mode
45.3.33 show ipv6 pim bsr-router
Command:
show ipv6 pim bsr-router
Function:
Display BSR address.
Command Mode:
Admin Mode and Global Mode
Example:
Switch#show ipv6 pim bsr-router
PIMv2 Bootstrap information
This system is the Bootstrap Router (BSR)