PLANET XGS3-24042 - Manual (Page 895)

45-40
debug ipv6 pim anycast-rp
no debug ipv6 pim anycast-rp
Function:
Enable the debug switch of ANYCAST RP function; the no operation of this command will disable
this debug switch.
Command Mode:
Admin Mode.
Default:
The debug switch of ANYCAST RP is disabled by default.
Usage Guide:
This command is used to enable the debug switch of ANYCAST RP of the router, it can display the
information of handling PIM register packet of the switch——packet, and the information of
events——event.
Example:
Switch#debug ipv6 pim anycast-rp
45.4.2 ipv6 pim anycast-rp
Command:
ipv6 pim anycast-rp
no ipv6 pim anycast-rp
Function:
Enable the ANYCAST RP of the switch; the no operation of this command is to disable the
ANYCAST RP function.
Command Mode:
Global Configuration Mode.
Default:
The switch will not enable the ANYCAST RP by default.
Usage Guide:
This command will globally enable ANYCAST RP protocol, but in order to make ANYCAST RP work,
it is necessary to configure self-rp-address and other-rp-address set.
Example:
Enable ANYCAST RP in global configuration mode.
Switch(config)#ipv6 pim anycast-rp
45.4.3 ipv6 pim anycast-rp