PLANET XGS3-24042 - Manual (Page 504)

33-143
detail shows the messages of received or sent data packets
Default: Debug switch closed.
Command Mode:
Admin mode and global mode
Example:
Switch# debug rip packet
Switch#1970/01/01 01:01:43 IMI: SEND[Vlan1]: Send to 224.0.0.9:520
1970/01/01 01:01:43 IMI: SEND[Vlan1]: Send to 224.0.0.9:520
1970/01/01 01:01:47 IMI: RECV[Vlan1]: Receive from 20.1.1.2:520
33.5 debug rip redistribute message send
Command:
debug rip redistribute message send
no debug rip redistribute message send
Function:
To enable the debugging of sending messages for routing redistribution messages from OSPF
process or BGP protocol for RIP. The no form of this command will disable the debugging
messages.
Default:
Close the debug by default.
Command Mode:
Admin Mode.
Example:
Switch#debug rip redistribute message send
Switch#no debug rip redistribute message send
33.6 debug rip redistribute route receive
Command:
debug rip redistribute route receive
no debug rip redistribute route receive
Function:
To enable debugging of received messages from NSM for RIP. The no form of this command will
disable debugging of received messages from NSM for RIP.