PLANET XGS3-24042 - Manual (Page 305)

16-151
Chapter 16 Commands for for
Flow-based Redirection
16.1 access-group redirect to interface ethernet
Command:
access-group <aclname> redirect to interface [ethernet <IFNAME> | <IFNAME>]
no access-group <aclname> redirect
Function:
Specify flow-based redirection; “no access-group <aclname> redirect” command is used to delete
flow-based redirection.
Parameters:
<aclname> name of the flow , only supports digital standard IP ACL, digital extensive IP ACL,
nomenclatural standard IP ACL, nomenclatural extensive IP ACL, digital standard IPv6 ACL, and
nomenclatural standard IPv6 ACL. Parameters of Timerange and Portrange can not be set in ACL;
the type of ACL should be Permit. <IFNAME> the destination port of redirection.
Command Mode:
Physical Port Configuration Mode.
Usage Guide:
“no access-group <aclname> redirect” command is used to delete flow-based redirection.
Flow-based redirection function enables the switch to transmit the data frames meeting some
special condition to another specified port.
Example: