PLANET XGS3-24042 - Manual (Page 607)

36-246
Command Mode:
Interface Configuration Mode.
Usage Guide:
The LSA ages by time in the layer 3 switches but not in the transmission process. So by increasing
the transmit-delay before sending LSA so that it will be sent out. The command can configure on
IPv6 tunnel interface, but it is successful configuration to only configure tunnel carefully.
Example:
Set the interface vlan 1 LSA sending delay to 3 seconds.
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 ospf transmit-delay 3
36.23 ipv6 router ospf
Command:
[no] ipv6 router ospf {area <area-id> [instance-id <instance-id>]| tag <tag>[instance-id
<instance-id>]}| tag <tag> area <area-id> [instance-id <instance-id>]}
Function:
Enable ospf route on the interface; the “no ipv6 router ospf {area <area-id> [instance-id
<instance-id>]| tag <tag>[instance-id <instance-id>]}| tag <tag> area <area-id> [instance-id
<instance-id>]}” command cancels this configuration.
Parameter:
<area-id> is an area ID which could be shown in digits ranging between 0～4294967295, or an
IPv4 address
<instance-id> is the interface instance ID ranging between 0~255 and defaulted at 0.
<tag> ospfv3 process identifier
Default:
Not configured
Command Mode:
Interface Configuration Mode.
Usage Guide:
To enable this command on the interface, the area id must be configured. The instance ID and
instance tag are optional. The ospfv3 process allows one routing instance for each instance ID. The
route can be enabled on a interface with a instance ID. If the instance IDs are different, several
OSPF process can be run on one interface. However different OSPF process should not use the
same instance ID The command can configure on IPv6 tunnel interface, but it is successful