PLANET XGS3-24042 - Manual (Page 183)

11-29
11.13 ethernet-oam errored-frame-seconds threshold
high
Command:
ethernet-oam errored-frame-seconds threshold high {<high-seconds> | none}
no ethernet-oam errored-frame-seconds threshold high
Function:
Configure the high threshold of errored frame seconds event, no command restores the default
value.
Parameter:
<high-seconds>, the high detection threshold of errored frame seconds event, ranging from 2 to
65535 seconds.
none, cancel the high threshold configuration
Default:
none
Command Mode:
Port mode
Usage Guide:
During the specific detection period, serious link event is induced if the number of errored frame
seconds is larger than or equal to the high threshold and the device notifies the peer by sending
Information OAMPDU of which the value of Link Fault flag in Flags field is 1. Note that the high
threshold should not be less than the low threshold. The definition of errored frame seconds is the
second in which errored frame is received.
Example:
Configure the high threshold of errored frame seconds event on port 1/0/4 to 3000.
Switch(Config-If-Ethernet1/0/4)#ethernet-oam errored-frame-seconds threshold high 3000
11.14 ethernet-oam errored-frame-seconds threshold
low
Command:
ethernet-oam errored-frame-seconds threshold low <low-seconds>
no ethernet-oam errored-frame-seconds threshold low
Function:
Configure the low threshold of errored frame seconds event, no command restores the default