PLANET XGS3-24042 - Manual (Page 717)

41-9
Function:
Configure BFD for the static route, no command cancels the configuration.
Parameter:
<name> is vrf name, <ipv4-address> is destination address, mask is the subnet mask, nexthop is
nexthop address
Command Mode:
Global mode
Default:
BFD is not configured for the static route.
Usage Guide:
Configure BFD for the route and specify the detection mode.
Example:
Configure BFD for the static route.
s3(config)#ip route 10.1.1.0/24 20.1.1.2 bfd
41.14 ipv6 ospf bfd enable
Command:
ipv6 ospf bfd enable
no ipv6 ospf bfd enable
Function:
Configure BFD for OSPFv3 protocol on the specific interface, no command cancels the
configuration.
Default:
BFD is no enabled for OSPFv3.
Command Mode:
Interface configuration mode
Usage Guide:
Configure BFD for OSPFv3 protocol enabled by the specific interface, BFD will inform OSPFv3 after
detect link fault and OSPFv3 will deal with it in best times.
Example:
Enable BFD for OSPFv3 on interface.
s5(config-if-vlan50)#ipv ospf bfd enable